What goes into it.
This video was recorded before release. The steps below follow Structure+ 1.2.0. The video may show an earlier version, so a panel can look slightly different.
- Towers: a Truss Base and vertical Straight Truss for each corner.
- Outriggers: four diagonal stabilisers selected from each tower base.
- Sleeve Blocks: they ride on the towers and carry the horizontal truss.
- Head Blocks: they cap each tower and take its profile automatically.
- Auto Roof: a gable, mono or pyramid canopy from four recognised truss supports.
Good to know.
A Sleeve Block reads the selected tower’s width, depth and chord diameter. The horizontals can be smaller or larger than the tower; adapter frames connect them without changing their profile.
Roofs and truss here are planning geometry. Structure+ makes no fabric, loading, wind or capacity claim.